so got my plastic warjack kit today... is there any way...

[MinaFangirlOfEverblight]

...to make the rocinate gunhand removable to interchange with the other bits? i may want to keep him open to be either a rover or nomad as needed using magnets...

[MinaFangirlOfEverblight]

wow, somehow this posted twice -_-; sorry everyone!

[sleet01]

I put actual chains on his gun, used wire pins to make the anchor points removable from the shoulder, and used a Revoltech Joint for the wrist so I could attach and detach the Rocinante parts. This isn't really all necessary, though; you should be able to do the same with the stock chain parts and pinning or magnets.

[PG_LunarSol]

On the subject of Rocinante, is his kit supposed to have two different chain bits or am I supposed to reshape one of them to fit on the front of the figure?

[sleet01]

Mine came with two subtly-different chain pieces; one was ever-so-slightly longer. Maybe by one chain link. I had to do some trimming to get the gun anchor points to fit into their slots.

[Choco]

I just assembled my Rocinante last night and it felt like they are actually made for specific sides. One of the gun points I think is slightly smaller than the other. I don't remember at this point which is which, but they fit in just right for me. A little bending to get the connections to the shoulder to fit properly, but otherwise, no complaints here.

[PG_LunarSol]

Sounds like I've got a mispack then. The two chains I have are absolutely identical and are shaped to connect with the back. Neither comes close to fitting in the front, to the point where I'd have to cut off a large piece of the anchor point with molded rivets to make it fit. Just wanted to be sure the part wasn't reused on purpose.