Cryx Slayer - RESIN

**demi_morgana** · 08-15-2011, 08:44 AM

Yup - it has FINALLY happened:
I moved Cryx resin big boy from the painitng desk into the glass case

Although it took me much more time than I hoped for and tho there's still some paint to be slapped (lets be frank: such a huge model always can always get some more paint) I am pretty satisfied of the final result.

I hope to see it on the desk sooner or later to apply more rust and chipped paint - and surely share the results here.

Hope you like it!

**PG_Agamemnon** · 08-15-2011, 08:47 AM

Looks good. You should taka pic of it next to a regular model for size comparison.

**demi_morgana** · 08-19-2011, 06:46 AM

Good point:

As it was mentioned on Polish WM boards - decent garden gnome proxy

**grimni22** · 08-19-2011, 06:59 AM

dude, EPIC!!! (in both ways)

**PG_Agamemnon** · 08-19-2011, 07:44 AM

Do bad you cant balance him on a 50mm base...

**mathieu** · 08-19-2011, 09:47 AM

Nice paint job on this guy!
Mine is chopped in many pieces due to a conversion I was planning on doing (might still happen someday...). I really like this model. Very sharp, clean resin cast pieces, impressively good compared to the quality of PP's current resin models.

**MrMiyagi** · 08-19-2011, 07:03 PM

Beautiful job. I wish they would do more resins.

**demi_morgana** · 08-20-2011, 12:03 AM

Cheers!

Originally Posted by Agamemnon

Do bad you cant balance him on a 50mm base...

It is possible to put every foot on separate 50mm base though!b

Originally Posted by mathieu

Nice paint job on this guy!
Mine is chopped in many pieces due to a conversion I was planning on doing (might still happen someday...). I really like this model. Very sharp, clean resin cast pieces, impressively good compared to the quality of PP's current resin models.

I also wanted to reposition the model but decided I am not going to risk - model is too pricey (and limited) to be screwed

Totally agree about casting quality - it was pracicaly flawless!

**gcflash** · 08-20-2011, 01:01 AM

While it may be difficult to put it on a 50mm base, I would use it as a proxy for a Wraith Engine!!! A model that awesome deserves to be on the table!

**demi_morgana** · 08-20-2011, 02:29 AM

Hmmm - good idea, it should fit 100mm base fine

**biohazardjonny** · 08-20-2011, 05:05 AM

Originally Posted by gcflash

While it may be difficult to put it on a 50mm base, I would use it as a proxy for a Wraith Engine!!! A model that awesome deserves to be on the table!

I 2nd this. I kinda wanted one but cant afford it. Looks great though.

**gcflash** · 08-20-2011, 01:27 PM

It will certainly make a Morty jack list look amazing with a gigantic 'Slayer Engine' helping out! I am so jealous, but in a good way

Thread: Cryx Slayer - RESIN

Thread Tools

Cryx Slayer - RESIN

Posting Permissions